ONKYO TX-NR1000 User Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 152
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
9
Before Using the TX-NR1000/TX-NR5000E
Notes:
The supplied batteries should last for about six
months, although this will vary with usage.
If the remote controller doesnt work reliably, try
replacing the batteries.
Dont mix new and old batteries, or different types of
batteries.
If you intend not to use the remote controller for a
long time, remove the batteries to prevent possible
leakage and corrosion.
Expired batteries should be removed as soon as
possible to prevent damage from leakage or
corrosion.
To use the remote controller, point it at the
TX-NR1000/TX-NR5000Es remote control sensor, as
shown below. The TX-NR1000/TX-NR5000Es
[STANDBY] indicator ashes while a signal is being
received from the remote controller.
Notes:
The remote controller may not work reliably if the
TX-NR1000/TX-NR5000E is subjected to bright
light, such as direct sunlight or inverter-type
uorescent lights. Keep this in mind when installing
the TX-NR1000/TX-NR5000E.
If another remote controller of the same type is used
in the same room, or the TX-NR1000/TX-NR5000E
is installed close to equipment that uses infrared rays,
the remote controller may not work reliably.
Dont put anything, such as a book, on the remote
controller, because the buttons may be pressed
inadvertently, thereby draining the batteries.
The remote controller may not work reliably if the
TX-NR1000/TX-NR5000E is installed in a rack
behind colored glass doors. Keep this in mind when
installing the TX-NR1000/TX-NR5000E.
The remote controller will not work if theres an
obstacle between it and the TX-NR1000/
TX-NR5000Es remote control sensor.
(RC-558M only) You can set the transmission signal
format to infrared (IR), or radio frequency (RF) for
use with the optional RF Receiver. This is useful
when, for example, the TX-NR1000/TX-NR5000E is
installed in a rack or is not in line of sight of the
remote controller.
To select AMP mode, press the scroll wheel. AMP
appears on the display.
Installing the Batteries
1
To open the battery compartment, press
the small hollow and slide off the cover.
2
Insert the three supplied batteries (AA/R6)
in accordance with the polarity diagram
inside the battery compartment.
3
Put the cover onto the remote controller
and slide it shut.
Using the Remote Controller
30˚
30˚
Approx. 16 ft. (5 m)
Remote control sensor
STANDBY indicator
TX-NR1000/
TX-NR5000E
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 151 152

Comments to this Manuals

No comments