ONKYO TX-NR1000 User Manual Page 87

  • Download
  • Add to my manuals
  • Print
  • Page
    / 152
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 86
87
Hardware Setup
In this section, you will perform the initial settings for the following scenarios.
When you want to change the TX-NR1000/TX-NR5000Es remote control ID.
When you want to x the TV Format setting to PAL or NTSC.
When you want to x the AM Frequency Step setting to 9 kHz or 10 kHz.
Remote ID
This section explains how to change the TX-NR1000/
TX-NR5000Es remote control ID. You may need to
change this if the TX-NR1000/TX-NR5000Es remote
controller interferes with other Onkyo components
located in the same room. You can select 1, 2, or 3 for
remote control ID.
If you change the TX-NR1000/TX-NR5000Es remote
control ID, be sure to select the same ID on the remote
controller (See page 142). The default ID for both the
TX-NR1000/TX-NR5000E and remote controller is 1.
Note:
It is recommended that you perform setup using the
[SETUP]/[SELECT/PRESET]/[CONTROL/TUNING]/
[EXIT] buttons of the TX-NR1000/TX-NR5000Es
front panel.
If the remote controller is used for setup, signals from
the remote controller will not be received just after the
remote control ID settings have been changed (See
Changing the Remote Controllers Control ID on
page 142 to change the remote control ID on the remote
controller).
TV Format (for all models other than USA and
Canadian models)
The settings in the TV Format sub-menu can be
congured for Main B and Zone 2 as well as for Main A.
When you want to recongure the settings to conform
to the television format used in the area where you use
the TX-NR1000/TX-NR5000E, use this sub-menu so
that no time is wasted on detection.
Auto:
This is the default setting. When you leave this
setting unchanged, the television format is detected and
automatically set by the TX-NR1000/TX-NR5000E.
PAL:
Use this setting when you know the television
format is PAL.
NTSC:
Use this setting when you know the television
format is NTSC.
Frequency Step
The setting in this sub-menu determines the incremental
or decremental amount when adjusting the AM tuner
frequency. The initial setting is 9 kHz, and this only
needs to be changed if you are using the TX-NR1000/
TX-NR5000E in a 10 kHz region.
9 kHz:
Select if 9 kHz increments are used in your area.
10 kHz:
Select if 10 kHz increments are used in your
area.
Remote Control Setup Sub-menu
TV Format Sub-menu
AM Frequency Setup Sub-menu
(Asian and Australian Models Only)
Page view 86
1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 151 152

Comments to this Manuals

No comments