ONKYO TX-NR1000 User Manual download pdf (Page 136)

136

Using the Remote Controller with Other Components

—Continued

You can teach the TX-NR1000/TX-NR5000E’s remote

controller new commands simply by transmitting com-

mands from another remote controller one at a time. For

example, by transmitting the Play and Stop commands

from your CD player’s remote controller, the

TX-NR1000/TX-NR5000E’s remote controller can be

taught to transmit those commands when its Play [ ]

and Stop [ ] buttons are pressed in CD mode.

This is convenient when you want to add commands to

buttons after entering a remote control code (See page

129).

Notes:

• The following buttons cannot be taught new com-

mands: [LIGHT], [CUSTOM], [MACRO], [MODE],

[INPUT], [ZONE 2], [ZONE 3], and the scroll wheel

button.

• The TX-NR1000/TX-NR5000E’s remote controller

can learn a total of 150 commands. However, the

commands of some remote controllers may use a lot

of memory, in which case, this total will be reduced.

• If the message “FULL” appears, the remote control-

ler cannot learn any more commands because its

memory is full.

• By default, the TX-NR1000/TX-NR5000E’s remote

controller knows the commands for controlling an

Onkyo CD player, cassette deck, DVD player, and

MD recorder (e.g., Play, Stop, Pause, etc., buttons).

You can teach these buttons new commands, although

the defaults will be restored if the remote controller is

reset.

• To teach a new command to a button that has already

been taught a command, simply repeat this proce-

dure.

• Like most remote controllers, the TX-NR1000/

TX-NR5000E’s remote controller uses infrared.

Commands from remote controllers that don’t use

infrared cannot be learned.

• When the remote controller’s batteries expire, all

learned commands will be lost and will have to

learned all over again, so don’t discard your other

remote controllers.

Learning Commands from Another

Remote Controller

Press and hold the [CUSTOM] but-

ton for more than three seconds.

The remote controller enters Custom

mode.

Roll the scroll wheel to select

“LEARN,” and then press the

scroll wheel.

Roll the scroll wheel to select the

the remote controller mode you

want to teach a new command,

and then press the scroll wheel.

On the TX-NR1000/TX-NR5000E’s

remote controller, press the button

you want to teach the new com-

mand.

If you press a button that cannot be

taught a new command, the message

“RETRY” appears and you should press

another button.

CUSTOM

Point the remote controllers at

each other, about 2 to 6 inches (5–

15 cm) apart, and then, on the

other remote controller, press the

button whose command you want

to learn.

When the command has been learned

successfully, “OK” appears on the dis-

play. You may need to press the button

several times.

If the command is not learned success-

fully, after the message “FAIL” has been

displayed, the mode select display reap-

pears (step 3), and you should try again.

To teach the TX-NR1000/

TX-NR5000E’s remote controller

more new commands, repeat

steps 3 through 5.

Press the [CUSTOM] button when

you’ve ﬁnished.

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 151 152

Comments to this Manuals

No comments

ONKYO TX-NR1000 User Manual Page 136

Comments to this Manuals

Related products and manuals for AV receivers ONKYO TX-NR1000