ONKYO TX-NR1000 User Manual download pdf (Page 142)

142

Other Settings for the Remote Controller

—Continued

This section explains how to change the remote control-

ler’s ID. You may need to change this if the

TX-NR1000/TX-NR5000E’s remote controller inter-

feres with other Onkyo components located in the same

room.

Note:

If you change the remote controller’s ID, be sure to

select the same ID on the TX-NR1000/TX-NR5000E.

For details on setting up the TX-NR1000/

TX-NR5000E’s remote control ID, refer to the “Remote

Control Setup Sub-menu” section on page 87. The

default ID for both the TX-NR1000/TX-NR5000E and

remote controller is 1.

Changing the Remote Controller’s

Control ID

Hold down the remote controller’s [CUS-

TOM] button for more than three seconds.

The remote controller enters Custom mode.

Roll the scroll wheel to select “SETUP”

menu, and then press the scroll wheel.

Roll the scroll wheel to select ID menu,

and then press the scroll wheel.

Roll the scroll wheel to select an

ID—1 (default), 2, or 3—and then

press the scroll wheel.

Select the same ID as that set on the

TX-NR1000/TX-NR5000E.

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 151 152

No comments

ONKYO TX-NR1000 User Manual Page 142