ONKYO TX-NR1000 User Manual download pdf (Page 69)

Enjoying Movies and Music in the

Remote Zone (Zone 2/3)

—

Continued

Recording a Source

The TX-NR1000/TX-NR5000E can not only record the

playing source but can also record a source while play-

ing another source. You can also combine a video and

audio to create a new source.

Signals that can be output to a video/audio recording

device vary with the type of jack connected. Check the

following conditions before starting recording:

Audio

• Signals (analog) from the ETHERNET, PH, or

AUDIO IN jacks are output only to the AUDIO OUT

jacks. Music signals of MP3, WMA, and WAVE to be

played with Net-Audio are also output only to analog

audio output jacks.

• No signal is output from the MULTI-CH IN jacks.

• No signal is output from the HDMI IN jacks. Record-

ing via the HDMI OUT jack is also disabled because

Rec Out is not available in Audio Output Assign.

• Signals from the DIGITAL IN OPTICAL or COAX-

IAL jacks are output to the DIGITAL OUT OPTI-

CAL or COAXIAL jacks. PCM signals are converted

into analog signals, and also output to the AUDIO

OUT jacks.

• Only PCM signals are output from the i.LINK

(AUDIO) terminals to the AUDIO OUT jacks. Digital

signals are output from the i.LINK (AUDIO) termi-

nals to the DIGITAL OUT OPTICAL or COAXIAL

jacks, but signals on Super Audio CD and DVD-

Audio are not output.

Video

• Video signals from the VIDEO IN, S VIDEO IN, or

COMPONENT VIDEO IN jack are output only to the

VIDEO OUT jacks.

• When not using Zone 2 or Zone 3, press the

[ZONE 2] (or [REC/ZONE 3]) button, and

then press the [STANDBY/ON] button. Or

press the [ZONE 2] (or [REC/ZONE 3]) but-

ton, and then turn the [SELECT/PRESET] dial

to select “Off.” In the case of Zone 2, the green

indicator on the input source button is turned

off, and in the case of Zone 3, the red indicator

is turned off.

• When operating in the main room, be sure to

conﬁrm that the [STANDBY] indicator is not

blinking, and then start operations. When not

using in the main room, press the [STANDBY/

ON] button. If the TX-NR1000/TX-NR5000E

is in the standby status, the power supply to

Zone 2 and Zone 3 is not switched off.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 151 152

Comments to this Manuals

No comments

ONKYO TX-NR1000 User Manual Page 69

Comments to this Manuals

Related products and manuals for AV receivers ONKYO TX-NR1000