Onkyo TX SR507 User Manual download pdf (Page 38)

100

First Time Setup—Continued

Using Audyssey 2EQ™

Notes:

• Before starting Audyssey 2EQ

™

Automatic Speaker

Setup, arrange the room and connect the speakers as

you would for enjoying movies. Changes to the room

after auto setup requires you run the auto setup again,

as room EQ characteristics may have changed.

• When starting the room correction and speaker setup,

do not stand between the speakers and microphone,

and avoid obstacles blocking the path between

speakers and microphone. This will produce

inaccurate results.

• Position the microphone at ear height of a seated

listener with the microphone tip pointed directly at the

ceiling using a tripod. Do not hold the microphone in

your hand during measurements as this will produce

innacurate results.

• Make the room as quiet as possible. Background noise

can disrupt the room measurements. Close windows,

silence cell phones, televisions, radios, air

conditioners, fluorescent lights, home appliances,

light dimmers, or other devices.

• Cell phones should be turned off or placed away from

all audio electronics during the measurement process

as Radio Frequency Interference (RFI) may cause

measurement disruptions (even if the cell phone is not

in use).

Turn on the AV receiver.

Set the speaker setup

microphone at the Main Listening

Position

(page 37), and

connect it to the SETUP MIC jack.

(TX-SR577)

The speaker setting menu appears.

If you change these settings, refer to

steps 5–6 on “Speaker Settings”

(page 40) or step 5 on “Setting the

Powered Zone 2” (page 81).

Notes:

• If any of your speakers is 4 ohms, change the

Speaker Impedance setting before running the

Audyssey 2EQ Room Correction and speaker

setup (see page 40).

• If the AV receiver is muted, it will be unmuted

automatically when the Audyssey 2EQ Room

Correction and Speaker Setup starts.

• Room correction and speaker setup cannot be

performed while a pair of headphones is connected.

• It takes about 10 minutes to complete the room

correction and speaker setup for three positions.

Total measurement time varies depending on the

number of speakers.

• Do not connect or disconnect any speakers during

room correction and speaker setup.

SETUP MIC

ON/STANDBY

ENTER

Speaker setup microphone

Audyssey indicator

Press [ENTER].

The room calibration and speaker setup starts.

Test tones are played through each speaker as

Audyssey 2EQ Room Correction and Speaker

Setup runs. This process takes a few minutes.

Please refrain from talking during measure-

ments and do not stand between speakers and

the microphone.

Note:

You can cancel the Room Correction and

Speaker Setup at any point in this procedure

simply by disconnecting the setup microphone.

When the following display appears,

move the speaker setup microphone to

measurement point

b (page 37), and

then press [ENTER].

Audyssey 2EQ performs more measurements.

This takes a few minutes.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 99 100

Comments to this Manuals

No comments

Onkyo TX SR507 User Manual Page 38

Comments to this Manuals

Related products and manuals for Acoustics Onkyo TX SR507