Onkyo TX SR507 User Manual download pdf (Page 96)

100

Troubleshooting—Continued

Can’t record

• On your recorder, make sure the correct input is

selected.

• To prevent signal loops and damage to the AV

receiver, input signals are not fed through to outputs

with the same name (e.g., TV/TAPE IN to TV/TAPE

OUT or VCR/DVR IN to VCR/DVR OUT).

• When the Pure Audio listening mode is selected,

video recording is not possible because no video

signals are output. Select another listening mode.

The sound changes when I connect my

headphones

• When a pair of headphones is connected, the listening

mode is set to Stereo, unless it’s already set to Stereo,

Mono, Direct, or Pure Audio, in which case it stays the

same. (Pure Audio listening mode is not available for

North American/Taiwan models.)

How do I change the language of a multiplex

source

• On the “Audio Adjust” menu, change the “Input

(Mux)” setting to “Main” or “Sub” (page 71).

The u functions don’t work

• To use u, you must make an u connection and an

analog audio connection (RCA) between the

component and AV receiver, even if they are

connected digitally (page 35).

• While Zone 2 is selected, the u functions don’t

work.

The AV receiver’s display doesn’t work

• The display is turned off when the Pure Audio

listening mode is selected. Select another listening

mode.

The following settings can be made for the

composite video inputs

You must use the buttons on the unit to make these

settings.

1. While holding down the input selector button for the

input source that you want to set, press the [SETUP]

button.

2. Use the Left and Right [e]/[r] buttons to change

the setting.

3. Press the [SETUP] button when you’ve finished.

•Video Attenuation

This setting can be made for the DVD/BD,

VCR/DVR, CBL/SAT, or AUX input.

If you have a games console connected to the

composite video input, and the picture isn’t very

clear, you can attenuate the gain.

Video ATT:0: (default).

Video ATT:2: Gain is reduced by 2 dB.

Recording

Others

The AV receiver contains a microcomputer for signal

processing and control functions. In very rare situations,

severe interference, noise from an external source, or

static electricity may cause it to lockup. In the unlikely

event that this happens, unplug the power cord from the

wall outlet, wait at least 5 seconds, and then plug it back

in again.

Onkyo is not responsible for damages (such as CD

rental fees) due to unsuccessful recordings caused by

this unit’s malfunction. Before you record important

data, make sure that the material will be recorded

correctly.

Before disconnecting the power cord from the wall

outlet, set the AV receiver to Standby.

1 2 ... 91 92 93 94 95 96 97 98 99 100

Comments to this Manuals

No comments

Onkyo TX SR507 User Manual Page 96

Comments to this Manuals

Related products and manuals for Acoustics Onkyo TX SR507