Onkyo TX SR507 User Manual download pdf (Page 40)

100

First Time Setup—Continued

If the impedance of any speaker is 4 ohms or more but

less than 6, set the Speaker Impedance to 4 ohms.

North American and Taiwan models do not support

speakers with an impedance of less than 6 ohms.

To use bi-amping, you must change the Speaker Type

setting. For hookup information, see page 19.

Notes:

• When bi-amping is used, the AV receiver is able to

drive up to 5.1 speakers in the main room.

• Before you change these settings, turn down the

volume.

Note:

This procedure can also be performed on the AV receiver

by using its [SETUP] button, arrow buttons, and

[ENTER] button.

Speaker Settings

Press the [RECEIVER] button,

followed by the [SETUP] button.

Use the Up and Down [q]/[w]

buttons to select “2. Speaker

Setup”, and then press [ENTER].

Use the Up and Down [q]/[w]

buttons to select “2-1.Sp

Settings”, and then press

[ENTER].

If you change these settings, you must run the

Audyssey 2EQ™ Room Correction and Speaker Setup

again (see page 37).

Use the Up and Down [q]/[w]

buttons to select “Impedance”,

and use the Left and Right

[e]/[r] buttons to select (not

North American and Taiwan

models):

4ohms: Select if the impedance of any

speaker is 4 ohms or more but

less than 6.

6ohms: Select if the impedances of all

speakers are between 6 and

16 ohms.

Use the Up and Down [q]/[w]

buttons to select “Sp Type”, and

use the Left and Right [e]/[r]

buttons to select (TX-SR577

only):

Normal: Select this if you’ve

connected your front speakers

normally.

Bi-Amp:Select this if you’ve

connected your front speakers

for bi-amped operation.

Note:

Powered Zone2 cannot be used if “Sp

Type” is set to “Bi-Amp”.

Use the Up and Down [q]/[w] but-

tons to select “SB/FH”, and then

use the Left and Right [e]/[r]

buttons to select (TX-SR577

only):

FrontHigh:

Select this if you’ve con-

nected your front high speak-

ers to the SURR BACK L/R

terminal posts.

SurrBack:

Select this if you’ve con-

nected your surround back

speakers to the SURR BACK

L/R terminal posts.

Note:

If the “Sp Type” setting is set to “Bi-

Amp”, or Powered Zone 2 is set to “Not

Act” (page 81), this setting cannot be

selected.

Press the [SETUP] button.

Setup closes.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 99 100

Comments to this Manuals

No comments

Onkyo TX SR507 User Manual Page 40

Comments to this Manuals

Related products and manuals for Acoustics Onkyo TX SR507