Onkyo TX SR507 User Manual download pdf (Page 68)

100

Advanced Setup—Continued

2-2. Sp Config (Speaker Configuration) (TX-SR577)

With these settings, you can specify which speakers are connected and a crossover frequency for each speaker. Specify

“FullBand” for speakers that can output low frequency bass sounds adequately, for example, speakers with a good

sized woofer. For smaller speakers, specify a crossover frequency. Sounds below the crossover frequency will be

output by the subwoofer instead of the speaker. Refer to your speaker’s manuals to determine the optimum crossover

frequencies.

Subwoofer Yes: Select if a subwoofer is connected (default).

No: Select if no subwoofer is connected.

Front

FullBand, 40Hz to 100Hz (default), 120Hz, 150Hz, 200Hz

Center

Surr

FrontH

*2*3*5*6

SurrBk

*3*4*5*7

FullBand, 40Hz to 100Hz, 120Hz, 150Hz, 200Hz

None: Select if no speaker is connected.

SurrBack ch

1ch: Select if only one surround back L speaker is connected.

2ch: Select if two (left and right) surround back speakers are connected (default).

LPFofLFE 80Hz, 90Hz, 100Hz (default), 120Hz

(Low-Pass Filter for the LFE Channel)

This setting is not set automatically by the Audyssey 2EQ™ Room Correction and Speaker Setup function

(see page 37).

With this setting, you can specify the cutoff frequency of the LFE channel’s low-pass filter (LPF), which can

be used to filter out unwanted hum. The LPF only applies to sources that use the LFE channel.

DoubleBass

This setting is not set automatically by the Audyssey 2EQ Room Correction and Speaker Setup function

(see page 37).

With the Double Bass function, you can boost bass output by feeding bass sounds from the front left and right

channels to the subwoofer.

On: Double Bass function on. Bass from the front left and right channels is also

fed to the subwoofer (default).

Off: Double Bass function off.

Notes:

*1 If the “Subwoofer” setting is set to “No”, the “Front” setting is fixed at “FullBand”.

*2 If the “Front” setting is set to anything other than “FullBand”, “FullBand” cannot be selected here.

*3 If the “Surr” setting is set to “None”, this setting cannot be selected.

*4 If the “Surr” setting is set to anything other than “FullBand”, “FullBand” cannot be selected here.

*5 If the “Sp Type” setting is set to “Bi-Amp” (page 40), or Powered Zone 2 is being used (page 81), this setting cannot be selected.

*6 If the “SB/FH” setting is set to “SurrBack” (page 40), this setting cannot be selected.

*7 If the “SB/FH” setting is set to “FrontHigh” (page 40), this setting cannot be selected.

*8 If the “SurrBk” Setting is set to “None” (page 68), this setting cannot be selected.

*9 This function can be set only if the “Subwoofer” setting is set to “Yes”, and the “Front” setting is set to “FullBand”.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 99 100

Comments to this Manuals

No comments

Onkyo TX SR507 User Manual Page 68

Comments to this Manuals

Related products and manuals for Acoustics Onkyo TX SR507