ONKYO TX-NR5009 Instruction Manual download pdf (Page 69)

With this preference, you can protect your settings by

locking the setup menus.

Main menu Lock Setup

■ Setup

` Locked

Unlocked

When “Locked” is selected, the setup menus will be

locked and you cannot change any setting.

You can change various audio settings from the Home

menu (➔ page 43).

Note

• These settings are not available in either of the following cases:

–the “Audio TV Out” setting is set to “On” (➔ page 66).

–“HDMI Control(RIHD)” is set to “On” (➔ page 66) and

you’re listening through your TV speakers.

Sound Program

■ Sound Program

` Stereo Source 1, Stereo Source 2, Stereo Source 3,

Multich Source 1, Multich Source 2, Multich

Source 3

Off

With this setting, you can select the combination of

settings that you registered in “Sound Program Edit”

(➔ page 58).

Note

• This setting is not available when the multichannel analog input

is selected.

• If the input selector is changed, the “Sound Program” setting is

switched back to “Off”.

Tone Control Settings

■ Bass

` –10dB to 0dB

to +10dB in 2 dB steps.

You can boost or cut low-frequency sounds output.

■ Treble

` –10dB to 0dB

to +10dB in 2 dB steps.

You can boost or cut high-frequency sounds output.

You can adjust the bass for the front, front wide, front

high, center, surround, surround back and subwoofer

speakers and treble for the front, front wide, front high,

center, surround and surround back speakers, except when

the Direct, Pure Audio or THX listening mode is selected.

Operating on the AV receiver

Note

• This setting is not available when the multichannel analog input

is selected.

Speaker Levels

■ Subwoofer 1

` –15.0dB to 0.0dB

to +12.0dB in 0.5 dB steps.

■ Subwoofer 2

` –15.0dB to 0.0dB to +12.0dB in 0.5 dB steps.

■ Center

` –12.0dB to 0.0dB

to +12.0dB in 0.5 dB steps.

You can adjust the volume of each speaker while listening

to an input source.

These temporary adjustments are cancelled when the AV

receiver is set to standby. To save the setting you made

here, go to “Level Calibration” (➔ page 54) before

setting the AV receiver to standby.

Note

• You cannot use these functions while the AV receiver is muted.

• These settings cannot be used while a pair of headphones is

connected.

• Speakers that are set to “No” or “None” in

“Speaker Configuration” (➔ page 52) cannot be adjusted.

If the “Subwoofer” setting is set to “1ch”, this setting cannot

be selected (➔ page 52).

Lock Setup

Using the Audio Settings

Press RECEIVER followed by HOME.

Use q/w and ENTER to select “Audio”, and then

use q/w/e/r to make the desired selection.

Press TONE repeatedly to select either “Bass” or

“Treble” for each speaker or subwoofer.

Use + and – to adjust.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 107 108

Comments to this Manuals

No comments

ONKYO TX-NR5009 Instruction Manual Page 69

Comments to this Manuals

Related products and manuals for AV receivers ONKYO TX-NR5009