ONKYO TX-NR5009 Instruction Manual download pdf (Page 46)

By using ACTIVITIES in Easy macro mode, you can

sequentially operate Onkyo components via simple

commands from a single-button press. These commands

are user-definable. See “Using Normal Macros”

(➔ page 84).

■ MY MOVIE

First, the TV, the Onkyo Blu-ray Disc player, and the AV

receiver are turned on. The input selector is set to

“BD/DVD”. Finally the player starts playback.

Depending on the start-up time of your Blu-ray Disc/DVD

player, the AV receiver may not activate this playback

command. In this case, press 1 on the remote controller.

■ MY TV

First, the TV, the cable set-top box, and the AV receiver

are turned on. Then the input selector is set to

“CBL/SAT”.

■ MY MUSIC

The Onkyo CD player and the AV receiver are turned on.

The input selector is set to “TV/CD”. Finally, the player

starts playback.

Note

• While the Easy Macro command is being processed, you cannot

use other ACTIVITIES. If you want to operate other

components, first press ALL OFF and use the desired

ACTIVITIES.

Turning Off the Components

This button turns off all components activated by the Easy

Macro mode.

First, the related components stop and turn off. Second,

the AV receiver turns off. Finally, the TV turns off (or

enters standby mode).

*1*2

This step doesn’t apply to MY MUSIC, with the default

settings.

With some televisions, the power may not be turned off (or

enter standby mode).

Changing the Source Components

You can change the source components activated by the

Easy Macro mode.

Examples:

If you wished to use MY MOVIE to start the playback

component assigned to VCR/DVR of REMOTE MODE,

you would press and hold down MY MOVIE for about 3

seconds while pressing down VCR/DVR of REMOTE

MODE.

Restoring Default

You can restore ACTIVITIES to the default settings.

This section explains how to record the selected input

source to a component with recording capability.

AV Recording

Audio sources can be recorded to a recorder (e.g., cassette

tape deck, CDR, MD recorder). Video sources can be

recorded to a video recorder (e.g., VCR, DVD recorder).

Using Easy Macros

Press ACTIVITIES (MY MOVIE, MY TV, or

MY MUSIC) to start the Easy macro command.

The default sequences of actions are described below.

To change the related source component, see

“Changing the Source Components” shown later in

this chapter.

Press ALL OFF.

While holding down REMOTE MODE for the

playback component you wish to assign, press and

hold down the ACTIVITIES to be changed

(MY MOVIE, MY TV, or MY MUSIC) (about 3

seconds).

ACTIVITIES flashes twice, indicating that the

change is complete.

While holding down HOME, press and hold down

ALL OFF until ALL OFF lights (about 3 seconds).

Release HOME and ALL OFF, and press ALL OFF

again.

ALL OFF flashes twice.

Recording

Use the input selector buttons to select the source

that you want to record.

You can watch the source while recording. The AV

receiver’s MASTER VOLUME control has no effect

on recording.

On your recorder, start recording.

On the source component, start playback.

If you select another input source during recording,

that input source will be recorded.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 107 108

Comments to this Manuals

No comments

ONKYO TX-NR5009 Instruction Manual Page 46

Comments to this Manuals

Related products and manuals for AV receivers ONKYO TX-NR5009