ONKYO TX-NR5009 Instruction Manual Page 22

  • Download
  • Add to my manuals
  • Print
  • Page
    / 108
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 21
22
En
With u (Remote Interactive), you can use the following
special functions:
Auto Power On
When you start playback on a component connected via
u while the AV receiver is on Standby, the AV
receiver will automatically turn on and select that
component as the input source.
Direct Change
When playback is started on a component connected via
u, the AV receiver automatically selects that
component as the input source.
System Off
When you turn off the AV receiver, the components
turn off automatically.
Remote Control
You can use the AV receiver’s remote controller to
control your other u-capable Onkyo components,
pointing the remote controller at the AV receiver’s
remote control sensor instead of the component. You
must enter the appropriate remote control code first
( page 81).
Note
•Use only u cables for u connections. u cables are supplied
with Onkyo components.
Some components have two u jacks. You can connect either
one to the AV receiver. The other jack is for connecting
additional u-capable components.
Connect only Onkyo components to u jacks. Connecting other
manufacturer’s components may cause a malfunction.
Some components may not support all u functions. Refer to
the manuals supplied with your Onkyo components.
While Zone 2/3 is on, the System Off, Auto Power On and Direct
Change u functions do not work.
See “Recording” for details on recording ( page 46).
Note
The AV receiver must be turned on for recording. Recording is
not possible while it’s in standby mode.
If you want to record directly from your TV or playback VCR to
the recording VCR without going through the AV receiver,
connect the TV/VCR’s audio and video outputs directly to the
recording VCR’s audio and video inputs. See the manuals
supplied with your TV and VCR for details.
Video signals connected to composite video inputs can be
recorded only via composite video outputs. For example, if your
TV/VCR is connected to a composite video input, the recording
VCR must be connected to a composite video output.
The surround sound and DSP listening modes cannot be
recorded.
Copy-protected Blu-ray Discs and DVDs cannot be recorded.
Sources connected to a digital input cannot be recorded. Only
analog inputs can be recorded.
DTS signals will be recorded as noise, so don’t attempt analog
recording of DTS CDs or LDs.
While the listening mode is set to Pure Audio, the video circuitry
is turned off and therefore no video signals are processed. If you
want to make recordings, select another listening mode.
Connecting Onkyo u Components
1
Make sure that each Onkyo component is
connected with an analog audio cable (connection
H in the hookup examples) ( page 20).
2
Make the u connection (see the illustration).
3
If you’re using an RI Dock or cassette tape deck,
change the Input Display ( page 44).
LR
ANALOG
AUDIO OUT
LR
ANALOG
AUDIO OUT
e.g., CD player
RI Dock
Connecting a Recording Component
AUDIO
IN
LR
VIDEO
IN
VCR, DVD recorder,
cassette tape deck,
CDR, MD recorder, etc.
Page view 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 107 108

Comments to this Manuals

No comments