ONKYO TX-NR5009 Instruction Manual download pdf (Page 45)

You can set which speakers you want to use by priority. You can temporarily mute the output of the AV receiver.

Selecting Speaker Layout

Press RECEIVER followed by SP LAYOUT

repeatedly to select:

■ 9.2 ch playback

` Speaker Layout:SB/FH:

The sounds from surround back and front high

speakers are output by priority.

` Speaker Layout:SB/FW:

The sounds from surround back and front wide

speakers are output by priority.

■ 7.2 ch playback

` Speaker Layout:FH:

The sound from front high speakers is output by

priority.

` Speaker Layout:FW:

The sound from front wide speakers is output

by priority.

Note

• This setting cannot be selected when bi-amping the front

speakers (➔ page 51) or using Speakers B (➔ page 51)

or Powered Zone 2 (➔ page 51).

• Playback conditions may be limited depending on the

settings in “Speaker Settings” (➔ page 51) and

“Speaker Configuration” (➔ page 52).

• When a listening mode which doesn’t support front high,

front wide or surround back speakers is used, this setting

cannot be selected.

■ Speakers A or Speakers B Configuration

When “Speakers Type(Front B)” setting is set to

other than “No”, the relevant speaker indicator

lights (A or B), and you can choose a speaker

layout between Speakers A and Speakers B.

Speakers A or B can be switched regardless of

listening modes.

Note

• When using Speakers B, you cannot use front wide

speakers.

• While using Speakers B, you cannot use

Audyssey MultEQ

XT32 Room Correction and Speaker

Setup, as well as Audyssey Dynamic EQ

and

Audyssey Dynamic Volume

Note that these layouts can only be selected

when “Front High + Front Wide” is set to “No”

(➔ page 51) and all speakers are enabled.

Note that these layouts can only be selected

when “Front High + Front Wide” is set to “No”

(➔ page 51) and front high and front wide

speakers are enabled (➔ page 52).

Muting the AV Receiver

Press RECEIVER followed by MUTING.

The output is muted and the MUTING indicator

flashes on the display.

Tip

• To unmute, press MUTING again or adjust the volume.

• Muting is automatically cancelled when the AV receiver is

set to standby.

Using Headphones

Connect a pair of stereo headphones with a

standard plug (1/4 inch or 6.3 mm) to the

PHONES jack.

While the headphones plug is inserted in the

PHONES jack, = indicator, speaker/channel

indicator FL and FR lights. (The Powered Zone 2/3

speakers are not turned off.)

Note

• Always turn down the volume before connecting your

headphones.

• When you connect a pair of headphones, the listening mode

is set to Stereo, unless it’s already set to Stereo, Mono,

Direct, or Pure Audio.

• If you connect an iPod or iPhone to the USB port on the

AV receiver, no sound will be output from the headphones

jack.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 107 108

Comments to this Manuals

No comments

ONKYO TX-NR5009 Instruction Manual Page 45

Comments to this Manuals

Related products and manuals for AV receivers ONKYO TX-NR5009