Onkyo TX SR607 User Manual download pdf (Page 84)

Advanced Setup—Continued

■ Zoom Mode (Zoom)

This setting determines the aspect ratio that will be used for

480i, 480p, 576i, and 576p input signals when they are out-

put by the HDMI OUT. This setting only applies when the

HDMI Output Resolution setting is set to 1080i or 720p.

Normal:

Full: (default)

■ Brightness

With this setting you can adjust the picture brightness.

Can be adjusted from –20 to +20 in steps of 1 (default is 0).

“–20” is the darkest.

“+20” is the brightest.

■ Contrast

With this setting you can adjust Contrast.

Can be adjusted from –20 to +20 in steps of 1 (default is

0).

“–20” is the least.

“+20” is the greatest.

■ Hue

With this setting you can adjust the red/green balance.

Can be adjusted from –20 to +20 in steps of 1 (default is

0).

“–20” is the strongest green.

“+20” is the strongest red.

■ Saturation

With this setting you can adjust saturation.

Can be adjusted from –20 to +20 in steps of 1 (default is

0).

“–20” is the weakest color.

“+20” is the strongest color.

■ Sharpness

With this setting you can adjust sharpness.

Can be adjusted from 0 to +5 in steps of 1 (default is 0).

“0” is the default.

“+5” is the sharpest.

The digital input signal formats are available only for the

input sources that you have assigned a digital input jack;

otherwise you will see “Analog” indicated on the screen

(see page 42).

Normally, the AV receiver detects the signal format auto-

matically. However, if you experience either of the fol-

lowing issues when playing PCM or DTS material, you

can manually set the signal format to PCM or DTS:

• If the beginnings of tracks from a PCM source are cut

off, try setting the format to PCM.

• If noise is produced when fast forwarding or reversing

a DTS CD, try setting the format to DTS.

• The setting is stored individually for each input selec-

tor.

Digital Input Signal Formats

Press the [RECEIVER] button, and then

press and hold [AUDIO] button for about

8 seconds.

While “Auto” is displayed (about 3 sec-

onds), press the Left and Right [e]/[r]

buttons to select: PCM, DTS or Auto.

PCM:

Only 2-channel PCM format input signals will be

heard. If the input signal is not PCM, the PCM indi-

cator will flash and noise may also be produced.

DTS:

Only DTS (but not DTS-HD) format input sig-

nals will be heard. If the input signal is not DTS,

the DTS indicator will flash and there will be no

sound.

Auto (default):

The format is detected automatically. If no digital

input signal is present, the corresponding analog

input is used instead.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 107 108

Comments to this Manuals

No comments

Onkyo TX SR607 User Manual Page 84

Comments to this Manuals

Related products and manuals for Acoustics Onkyo TX SR607