Onkyo TX SR607 User Manual download pdf (Page 37)

Connecting the AV Receiver—Continued

With u (Remote Interactive), you can use the follow-

ing special functions:

■ Auto Power On/Standby

When you start playback on a component connected

via u, if the AV receiver is on Standby, it will auto-

matically turn on and select that component as the

input source. Similarly, when the AV receiver is set

to Standby, all components connected via u will

also go on Standby.

■ Direct Change

When playback is started on a component connected

via u, the AV receiver automatically selects that

component as the input source.

■ Remote Control

You can use the AV receiver’s remote controller to

control your other u-capable Onkyo components,

pointing the remote controller at the AV receiver’s

remote control sensor instead of the component. You

must enter the appropriate remote control code first

(see page 92).

Notes:

•Use only u cables for u connections. u cables

are supplied with Onkyo players (DVD, CD, etc.).

• Some components have two u jacks. You can con-

nect either one to the AV receiver. The other jack is for

connecting additional u-capable components.

• Connect only Onkyo components to u jacks. Con-

necting other manufacturer’s components may cause a

malfunction.

• Some components may not support all u functions.

Refer to the manuals supplied with your other Onkyo

components.

• While Zone 2 is on, the Auto Power On/Standby and

Direct Change u functions do not work.

Notes:

• Before connecting the power cord, connect all of

your speakers and AV components.

• Turning on the AV receiver may cause a momentary

power surge that might interfere with other electrical

equipment on the same circuit. If this is a problem,

plug the AV receiver into a different branch circuit.

• Do not use a power cord other than the one supplied

with the AV receiver. The supplied power cord is

designed exclusively for use with the AV receiver and

should not be used with any other equipment.

• Never disconnect the power cord from the AV receiver

while the other end is still plugged into a wall outlet.

Doing so may cause an electric shock. Always discon-

nect the power cord from the wall outlet first, and then

the AV receiver.

Connecting Onkyo u Components

Step 1:

Make sure that each Onkyo component is connected

to the AV receiver with an analog audio cable (con-

nection in the hookup examples) (see pages 27 to

35).

Step 2:

Make the u connection (see illustration below).

Step 3:

If you’re using an MD, CDR, or RI Dock, change the

Input Display (see page 45).

Connecting the Power Cord

DVD/BD

REMOTE

CONTROL

ANALOG

AUDIO OUT

ANALOG

AUDIO OUT

e.g., CD player

e.g., DVD player

Step 1 (On some model):

Connect the supplied power cord to the AV receiver’s

AC INLET.

Step 2:

Plug the power cord into an AC wall outlet.

To AC wall outlet

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 107 108

Comments to this Manuals

No comments

Onkyo TX SR607 User Manual Page 37

Comments to this Manuals

Related products and manuals for Acoustics Onkyo TX SR607