ONKYO TX-SR604/604E User Manual download pdf (Page 67)

Advanced Setup

Some of the settings in this section are set automatically

by the Automatic Speaker Setup function (see page 38).

Here you can check the settings made by the Automatic

Speaker Setup function, or set them manually, which is

useful if you change one of the connected speakers after

using the Automatic Speaker Setup function.

Speaker Conﬁguration

With these settings, you can specify which speakers are

connected and a crossover frequency for each speaker.

The following crossover frequencies can be speciﬁed:

Full Band, 40 Hz, 50 Hz, 60 Hz, 80 Hz, 100 Hz, 120 Hz,

150 Hz, 200 Hz.

Specify Full Band for speakers that can output low-fre-

quency bass sounds adequately, for example, speakers

with a good sized woofer. For smaller speakers, specify

a crossover frequency. Sounds below the crossover fre-

quency will be output by the subwoofer instead of the

speaker. Refer to your speakers’ manuals to determine

the optimum crossover frequencies.

Speaker Setup

Press the [RECEIVER] button fol-

lowed by the [SETUP] button.

The main menu appears onscreen.

This setting is set automatically by the Automatic

Speaker Setup function (see page 38).

MUTING

GUIDE

TOP MENU

SETUPRETURN

PLAYLIST/CAT PLAYLIST/CAT

---

TAPE

D/CDR

HDD

CABLE

ON/STANDBY

DIMMER

ENT

D TUN

SLEEP

10 11 12

INPUT SELECTOR

REMOTE MODE

ZONE2

V2 V3

DTAPE TUNER

DVD

MULTI CH

VOL

SAT

VCR

DVD

RECEIVER

INPUT

CLR

123

456

789

ENTER

DISC

ALBUM

1, 11

2-10

RECEIVER

SETUP

Use the Up and Down [ ]/[ ]

buttons to select “1. Speaker

Conﬁg,” and then press [ENTER].

The Speaker Conﬁg menu appears.

Use the Up and Down [ ]/[ ]

buttons to select “a. Subwoofer,”

and then use the Left and Right

[ ]/[ ] buttons to select:

Yes: Select if a subwoofer is con-

nected.

No: Select if no subwoofer is con-

nected.

Use the Up and Down [ ]/[ ]

buttons to select “b. Front,” and

then use the Left and Right [ ]/

[ ] buttons to select a crossover

frequency.

Note:

If the Subwoofer setting in step 3 is set

to No, this setting is ﬁxed at Full Band.

Use the Up and Down [ ]/[ ]

buttons to select “c. Center,” and

then use the Left and Right [ ]/

[ ] buttons to select a crossover

frequency.

If no center speaker is connected, select

None.

Note:

If the Front setting in step 4 is set to

anything other than Full Band, Full

Band cannot be selected here.

1.Speaker Config

------------------------

a.Subwoofer :Yes

b.Front : 100Hz

c.Center : 100Hz

d.Surround : 100Hz

e.SurrBack : 100Hz

f.SurrBack Ch :2ch

g.LPFofLFE : 120Hz

h.DoubleBass :---

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 91 92

Comments to this Manuals

[email protected] 12 Nov 2024 | 03:54:02

This is your amplifier Onkyo TX SR604

ONKYO TX-SR604/604E User Manual Page 67

Comments to this Manuals

Related products and manuals for AV receivers ONKYO TX-SR604/604E