ONKYO TX-SR604/604E User Manual download pdf (Page 50)

Basic Operations—Continued

The multichannel DVD input is for connecting a compo-

nent with a 7.1-channel analog audio output, such as a

DVD-Audio or SACD-capable DVD player, or an

MPEG decoder. See page 26 for hookup information.

Note:

While the multichannel DVD input is selected, the

Speaker Conﬁguration settings on page 67 are ignored,

and signals from the multichannel input are fed to the

speakers as they are.

You can adjust the bass and treble for the front speakers,

except when the Direct or Pure Audio (not North Amer-

ican models) listening mode is selected.

■ Bass

You can boost or cut low-frequency sounds output by the

front speakers from –10 dB to +10 dB in 2 dB steps.

■ Treble

You can boost or cut high-frequency sounds output by

the front speakers from –10 dB to +10 dB in 2 dB steps.

You can display various information about the current

input source as follows.

Note:

This procedure can also be performed on the AV receiver

by using its [DISPLAY] button.

The following information can typically be displayed for

input sources.

*If the input signal is analog, no format information is

displayed. If the input signal is PCM, the sampling fre-

quency is displayed. If the input signal is digital but not

PCM, the signal format is displayed. Information is

displayed for about three seconds, then the previously

displayed information reappears.

Interpreting Surround Channel Values

A: The number of front channels (3 means front left,

front right, and center).

B: The number of surround channels (2 means surround

left and surround right). If there’s surround back

channel information, this will be 3.

C: LFE channel for subwoofer (1 means yes).

Using the Multichannel DVD Input

Press the [RECEIVER] button,

followed by the [MULTI CH] but-

ton.

The MULTI CH indicator appears on

the display.

Audio from the multichannel DVD

input will now be used for the DVD

input source.

Adjusting the Bass & Treble

Press the [TONE] button repeat-

edly to select either Bass or

Treble.

Use the TONE [–]/[+] buttons to

adjust.

RECEIVER

MULTI CH

MULTI CH indicator

TONE

Displaying Source Information

Press the [RECEIVER] button,

and then press the [DISPLAY]

button repeatedly to cycle

through the available informa-

tion.

RECEIVER

DISPLAY

Input source &

volume

Signal format*

or sampling

frequency

Input source &

listening mode

ABC

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 91 92

Comments to this Manuals

[email protected] 12 Nov 2024 | 03:54:02

This is your amplifier Onkyo TX SR604

ONKYO TX-SR604/604E User Manual Page 50

Comments to this Manuals

Related products and manuals for AV receivers ONKYO TX-SR604/604E