ONKYO TX-SR604/604E User Manual download pdf (Page 52)

Listening to the Radio

With the built-in tuner you can enjoy AM and FM radio

stations. You can store your favorite stations as presets

for quick selection.

Listening to the Radio

Tuning into Radio Stations

■

Auto Tuning Mode

When tuned into a station, the TUNED indicator

appears. When tuned into a stereo FM station, the FM

STEREO indicator appears on the display, as shown.

■

Manual Tuning Mode

The North American models change FM frequency in

0.2 MHz steps, 10 kHz steps for AM. For other models

it’s 0.05 MHz steps for FM and 9 kHz steps for AM.

In Manual Tuning mode, FM stations will be in mono.

Tuning into weak FM stereo stations

If the signal from a stereo FM station is weak, it may be

impossible to get good reception. In this case, switch to

Manual Tuning mode and listen to the station in mono.

■

Tuning into Stations by Frequency

You can tune into AM and FM stations directly by enter-

ing the appropriate frequency.

Using the Tuner

Use the [TUNER] input selector

button to select either AM or FM.

In this example, FM has been selected.

Each time you press the [TUNER] but-

ton, the input source changes between

AM and FM.

(Actual display depends on country)

Press the [TUNING MODE] button

so that the AUTO indicator

appears on the display.

Press the TUNING Up or Down

[ ]/[ ] button.

Searching stops when a station is

found.

TUNER

Band Frequency

TUNING

MODE

TUNING PRESET

AUTOTUNED

FM STEREO

Press the [TUNING MODE] button

so that the AUTO indicator disap-

pears from the display.

Press and hold the TUNING Up or

Down [ ]/[ ] button.

The frequency stops changing when

you release the button.

Press the buttons repeatedly to change

the frequency one step at a time.

Press the [RECEIVER] button,

followed by the [D TUN] button.

(Actual display depends on country.)

The [RECEIVER] button ﬂashes.

Within 8 seconds, use the num-

ber buttons to enter the fre-

quency of the radio station.

For example, to tune to 87.5 (FM),

press 8, 7, 5.

Note

: While the [RECEIVER] button is

ﬂashing, the input source cannot be

changed by using the remote controller.

TUNING

MODE

TUNING PRESET

RECEIVER

D TUN

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 91 92

Comments to this Manuals

[email protected] 12 Nov 2024 | 03:54:02

This is your amplifier Onkyo TX SR604

ONKYO TX-SR604/604E User Manual Page 52

Comments to this Manuals

Related products and manuals for AV receivers ONKYO TX-SR604/604E