ONKYO TX-8030 Instruction Manual download pdf (Page 19)

En-19

Enjoying Audio Sources—Continued

You can adjust the brightness of the display.

Press the remote controller’s [DIMMER] button

repeatedly to select: dim, dimmer, or normal

brightness.

With the sleep timer, you can set the receiver so that it

turns off automatically after a specified period.

Press the remote controller’s [SLEEP] button

repeatedly to select the required sleep time.

You can set the sleep time from 90 to 10 minutes in 10

minute steps.

The SLEEP indicator appears on the display when the

sleep timer has been set, as shown. The specified sleep

time appears on the display for about 5 seconds; then the

previous display reappears.

To cancel the sleep timer, press the [SLEEP] button

repeatedly until the SLEEP indicator disappears.

To check the remaining sleep time, press the [SLEEP]

button. Note that if you press the [SLEEP] button while

the sleep time is being displayed, you’ll shorten the sleep

time by 10 minutes.

This section explains functions the following can be

used with any input source.

Adjusting the Bass

The BASS control adjusts bass sounds.

Turn it up to make them louder. Turn it

down to make them quieter. Normally, it

should be set midway.

Adjusting the Treble

The TREBLE control adjusts treble

sounds. Turn it up to make them louder.

Turn it down to make them quieter.

Normally, it should be set midway.

Adjusting the Balance

The BALANCE control is used to

control the relative volume level of the

left and right speaker systems.

SLEEP

DIMMER

BASS

TREBLE

BALANCE

Setting the Display Brightness

(remote controller only)

Using the Sleep Timer

(remote controller only)

SLEEP Indicator

Using the Tone and Balance Controls

1 ... 18 19 20 ... 40

Comments to this Manuals

No comments

ONKYO TX-8030 Instruction Manual Page 19

Comments to this Manuals

Related products and manuals for AV receivers ONKYO TX-8030