ONKYO TX-8030 Instruction Manual download pdf (Page 11)

En-11

Connecting the Receiver—Continued

On the receiver, the factory default for speaker impedance is “6 Ω”. If you need to change the speaker impedance setting,

read “Speaker Connection Precautions” on page 9 carefully before performing the procedure below.

Note:

Be sure to minimize the volume level on the receiver

before configuring the speaker impedance.

Press the [] button to turn on the power.

Press the [SETUP] button on the remote

controller.

Use the arrow []/[] buttons to select

“2. Hardware Setup,” and then press

[ENTER].

Change the impedance value to “4 Ω” using

the arrow []/[] buttons.

Press the [SETUP] button on the remote

controller to complete the setting.

If you want to change the impedance setting back

to the factory default setting of 6 Ω, follow the

same procedure described above.

Notes:

• This procedure can also be performed on the receiver

by using [SETUP,] TUNING []/[], PRESET

[]/[], and [ENTER].

• Press [RETURN] button to return to the previous

menu.

Setting example :

If you’re using only one of the speaker sets connected to

SPEAKERS A or B, choose the 4 Ω setting if each

speaker’s impedance is 4 Ω to less than 6 Ω, or choose

the 6 Ω setting if each speaker’s impedance is 6 Ω or

more.

If you’re using both of the speaker sets connected to

SPEAKERS A and B, choose the 4 Ω setting if each

speaker’s impedance is 8 to 16 Ω.

Configuring the Speaker Impedance

ENTER



SETUP



1 ... 10 11 12 ... 40

No comments

ONKYO TX-8030 Instruction Manual Page 11