Onkyo A-9555 User Manual download pdf (Page 14)

Enjoying Audio Sources

If the A-9755/A-9555 is connected to other compo-

nents via , press the remote controller’s [ON] but-

ton once to turn on the A-9755/A-9555, and press it

again to turn on the other components.

Turning on all system components simultaneously:

You can set the A-9755/A-9555 so that all connected

components are turned on with just one press of the

remote controller’s [ON] button. To do this, turn on the

A-9755/A-9555, and then press and hold the remote con-

troller’s [ON] button for 16 seconds until the

A-9755/A-9555 switches to Standby mode. You will

then be able to turn on the A-9755/A-9555 and all sys-

tem components with just one press of the remote con-

troller’s [ON] button.

If you want to restore the setting to the original state,

reset the A-9755/A-9555. For information about how to

reset, see “How to reset” on page 19.

Note:

To shut down the A-9755/A-9555 completely, set the

[POWER] switch to the OFF position ( ).

You can select which set of speakers outputs sound.

OFF: Select “OFF,” if you do not connect any speaker.

A: To output sound from the speakers connected to the

SPEAKERS A terminals, turn the SPEAKERS selector

to the “A” position.

B: To output sound from the speakers connected to the

SPEAKERS B terminals, turn the SPEAKERS selector

to the “B” position.

A+B: To output sound from all connected speakers, turn

the SPEAKERS selector to the “A+B” position.

Note:

If the Volume indicator ﬂashes quickly, make sure that

the speakers are connected correctly.

Turning On the A-9755/A-9555

Press the [POWER] switch.

The A-9755/A-9555 retains the power

mode (on/standby) in which the ampli-

ﬁer was the last time you turned off the

system.

Notes:

• The A-9755/A-9555 is shipped with

the [POWER] switch in the OFF

position ( ). When the power cord

is connected for the very ﬁrst time or

the [POWER] switch is set to ON

( ) position, the A-9755/A-9555

will turn on.

• When it’s turned on, the

A-9755/A-9555 outputs no sound

for about ﬁve seconds. This allows

the circuits to stabilize.

To set the A-9755/A-9555 to

Standby, press the [STANDBY]

button on the remote controller.

The STANDBY indicator lights up.

To turn the A-9755/A-9555 on,

press the [ON] button on the

remote controller.

The STANDBY indicator goes off.

POWER

STANDBY

indicator

A-9755/

A-9555

Remote

controller

Selecting Speaker

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Onkyo A-9555 User Manual Page 14

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Onkyo A-9555