ONKYO DV-SP305 User Manual download pdf (Page 54)

Troubleshooting—Continued

Note:

• Static electricity or other external influences may cause malfunctioning of this unit. In this case, unplug the power

cord and then plug back in. This will usually reset the unit for proper operation. If this does not correct the problem,

please consult your nearest our customer center.

Remote Controller

Buttons on the

DV-SP305 work OK but

those on the remote

controller don’t?

There are no batteries in the remote

controller.

Install new batteries (page 10).

The batteries are flat. Replace with new batteries (page 10).

The batteries are installed incorrectly.

Check the batteries and correct as necessary

(page 10).

You’re not pointing the remote controller

at the DV-SP305’s remote sensor.

Point the remote controller at the DV-SP305’s

remote sensor (page 10).

You’re too far away from the DV-SP305.

Use the remote controller closer to the DV-SP305

(page 10). The remote controller has a range of

approximately 5 meters.

A strong light source is interfering with

the DV-SP305’s remote sensor.

Make sure that the DV-SP305 is not subjected to

direct sunshine or inverter-type fluorescent lights.

Relocate if necessary.

If the DV-SP305 is installed in a cabinet

with colored glass doors, the remote con-

troller may not work reliably when the

doors are closed.

Open the doors, or use a cabinet without colored

glass.

The DV-SP305 contains a microcomputer for signal processing and control functions. In very rare situations, severe

interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely even that this

should happen, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.

1 2 ... 49 50 51 52 53 54 55 56

No comments

ONKYO DV-SP305 User Manual Page 54