ONKYO DV-SP305 User Manual download pdf (Page 10)

Before Using the DV-SP305

Notes:

• If the remote controller doesn’t work reliably, try

replacing both batteries.

• Don’t mix new and old batteries, or different types of

batteries.

• If you intend not to use the remote controller for a long

time, remove the batteries to prevent possible leakage

and corrosion.

• Flat batteries should be removed as soon as possible to

prevent possible leakage and corrosion.

To use the remote controller, point it at the DV-SP305’s

remote control sensor, as shown below.

Notes:

• The remote controller may not work reliably if the

DV-SP305 is subjected to bright light, such as direct

sunlight or inverter-type fluorescent lights. Keep this

in mind when installing the DV-SP305.

• If another remote controller of the same type is used in

the same room, or the DV-SP305 is installed close to

equipment that uses infrared rays, the remote control-

ler may not work reliably.

• Don’t put anything, such as a book, on the remote con-

troller, because the buttons may be pressed inadvert-

ently, thereby draining the batteries.

• The remote controller may not work reliably if the

DV-SP305 is installed in a rack behind colored glass

doors. Keep this in mind when installing the

DV-SP305.

• The remote controller will not work if there’s an

obstacle between it and the DV-SP305’s remote con-

trol sensor.

Installing the Batteries

Open the battery compartment, as shown.

Insert the two supplied batteries (AA) in

accordance with the polarity diagram

inside the battery compartment.

Close the battery compartment.

Using the Remote Controller

30˚

DV-SP305

Remote control sensor

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

No comments

ONKYO DV-SP305 User Manual Page 10