Onkyo HT-R390 User Manual download pdf (Page 34)

Menu Hardware

OSD

■ Volume OSD

` On

` Off

You can select if you wish to display the volume level on-

screen, when it is adjusted.

Remote Control

■ Remote ID

` 1

, 2, or 3

When several Onkyo components are used in the same

room, their remote ID codes may overlap. To differentiate

the AV receiver from the other components, you can

change its remote ID from “1”, to “2” or “3”.

Note

• If you do change the AV receiver’s remote ID, be sure to change

the remote controller to the same ID (see below), otherwise, you

won’t be able to control it with the remote controller.

Changing the remote controller’s ID

Tuner

■ AM/FM Freq Step (North American and Brazilian

models)

` 10kHz/200kHz:

` 9kHz/50kHz:

Select the frequency step according to your area.

■ AM Freq Step (European and Asian models)

` 10kHz:

` 9kHz

Select the frequency step according to your area.

For AM/FM tuning to work properly, you must specify the

AM/FM frequency step used in your area. Note that when

this setting is changed, all radio presets will be deleted.

Auto Standby

■ Auto Standby

` Off

` On

When “Auto Standby” is set to “On”, AV receiver will

automatically perform standby operation if there is no

operation for 30 minutes with no audio and no video

signal input.

“Auto Standby” will display on the display and OSD

from 30 seconds before the Auto Standby functions.

Default setting: On (European and Asian models), Off

(North American and Brazilian models)

Note

• Depending on some sources, the Auto Standby function may

activate during playback.

UP-A1

■ UP-A1 ChargeMode

` Auto

Power feeding is interrupted when your iPod/iPhone

is fully charged.

` On:

Power feeding continues even if your iPod/iPhone is

fully charged.

` Off:

Your iPod/iPhone is not charged.

You can specify how the power is fed to your iPod/iPhone

when the AV receiver is in Standby Mode.

Note

• This setting cannot be selected when:

– the UP-A1 Dock with docked iPod/iPhone is not connected to

the AV receiver, or

– the docked iPod/iPhone model is not supported.

•When the “UP-A1 ChargeMode” setting is set to “On”, or to

“Auto” with your iPod/iPhone recharging, the SLEEP indicator

is dimly lit in standby mode. In such conditions, the power

consumption of the AV receiver slightly increases.

Menu HDMI Setup

■ HDMI Ctrl (RIHD)

` Off

` On

Turn this setting on to allow p-compatible

components connected via HDMI to be controlled by the

AV receiver (➔ page 50).

Hardware

While holding down RECEIVER, press and hold

down SETUP until the remote indicator lights

(about 3 seconds) (➔ page 27).

Use the number buttons to enter ID 1, 2, or 3.

The remote indicator flashes twice.

HDMI Setup

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 55 56

Comments to this Manuals

No comments

Onkyo HT-R390 User Manual Page 34

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Onkyo HT-R390