Onkyo HT-R390 User Manual download pdf (Page 30)

Menu Sp Distance

Here you can specify the distance from each speaker to the

listening position so that the sound from each speaker

arrives at the listener’s ears as the sound designer

intended.

Note

• These settings are disabled when:

– a pair of headphones is connected, or

–the “Audio TV Out” setting is set to “On” (➔ page 35), or

–“HDMI Ctrl (RIHD)” is set to “On” (➔ page 34) and

you’re listening through your TV speakers, or

– Speakers B is on, or

– Speakers A is off.

• Speakers that you set to “No” or “None” in the “Sp Config

(Speaker Configuration)” (➔ page 29) cannot be selected.

■ Unit

` feet:

Distances can be set in feet. Range: 1ft to 30ft in

1 foot steps.

` meters:

Distances can be set in meters. Range: 0.3m to 9.0m

in 0.3 meter steps.

(The default setting varies from country to country.)

■ Left, Center, Right, Surround Right, Surround

Left, Subwoofer

` Specify the distance from the each speaker to your

listening position.

Menu Level Cal

Here you can adjust the level of each speaker with the

built-in test tone so that the volume of each speaker is the

same at the listening position.

■ Left, Center

, Right, Surround Right, Surround

Left

` –12 dB to 0dB to +12 dB in 1 dB step.

■ Subwoofer

` –15 dB to 0dB to +12 dB in 1 dB step.

Default setting: 0dB (excluding European models),

+3 dB (European models)

Note

• Speakers that you set to “No” or “None” in the “Sp Config

(Speaker Configuration)” (➔ page 29) cannot be selected.

• These settings cannot be calibrated in either of the following

cases:

– a pair of headphones is connected.

– Speakers B is on.

– Speakers A is off.

–the “Audio TV Out” setting is set to “On” (➔ page 35).

–“HDMI Ctrl (RIHD)” is set to “On” (➔ page 34) and

you’re listening through your TV speakers.

– the AV receiver is muted.

For the center speaker and subwoofer, the level settings made

by using AUDIO are saved here as the default settings.

Tip

• If you’re using a handheld sound level meter, adjust the level of

each speaker so that it reads 75 dB SPL at the listening position,

measured with C-weighting and slow reading.

• To fully enjoy Audyssey Dynamic EQ

(➔ page 32) and

Audyssey Dynamic Volume

(➔ page 32), we recommend

that you manually adjust the level of each speaker using the

above-mentioned settings.

Sp Distance (Speaker Distance) Level Cal (Level Calibration)

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 55 56

Comments to this Manuals

No comments

Onkyo HT-R390 User Manual Page 30

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Onkyo HT-R390