ONKYO TX-SA706 User Manual download pdf (Page 14)

Remote Controller

Notes:

• If the remote controller doesn’t work reliably, try

replacing the batteries.

• Don’t mix new and old batteries or different types of

batteries.

• If you intend not to use the remote controller for a long

time, remove the batteries to prevent damage from

leakage or corrosion.

• Expired batteries should be removed as soon as possi-

ble to prevent damage from leakage or corrosion.

To use the remote controller, point it at the AV

receiver/AV amplifier’s remote control sensor, as shown

below.

Notes:

• The remote controller may not work reliably if the AV

receiver/AV amplifier is subjected to bright light, such

as direct sunlight or inverter-type fluorescent lights.

Keep this in mind when installing.

• If another remote controller of the same type is used in

the same room, or the AV receiver/AV amplifier is

installed close to equipment that uses infrared rays,

the remote controller may not work reliably.

• Don’t put anything, such as a book, on the remote con-

troller, because the buttons may be pressed inadvert-

ently, thereby draining the batteries.

• The remote controller may not work reliably if the AV

receiver/AV amplifier is installed in a rack behind col-

ored glass doors. Keep this in mind when installing.

• The remote controller will not work if there’s an

obstacle between it and the AV receiver/AV ampli-

fier’s remote control sensor.

• When the remote control codes have been registered

and you want to operate another component

(page 102), or when you want to operate an Onkyo

component without u connection, point the remote

controller at the other component to use it.

• When you want to operate an Onkyo component with

u connection or an -compatible compo-

nent connected via HDMI (page 104), point the

remote controller at the AV receiver/AV amplifier’s

remote control sensor.

Installing the Batteries

To open the battery compartment, press

the small lever and remove the cover.

Insert the two supplied batteries (AA/R6)

in accordance with the polarity diagram

inside the battery compartment.

Replace the cover and push it shut.

Aiming the Remote Controller

Remote control sensor

AV receiver/AV amplifier

Approx. 16 ft. (5 m)

STANDBY indicator

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 119 120

Comments to this Manuals

No comments

ONKYO TX-SA706 User Manual Page 14

Comments to this Manuals

Related products and manuals for AV receivers ONKYO TX-SA706