ONKYO TX-8555 User Manual download pdf (Page 15)

Connecting Your Speakers—Continued

In this model, the factory default for speaker impedance is “8 ohms.” When you change the speaker impedance setting,

read “Speaker Connection Precautions” on page 13 carefully before performing the procedures below.

Note:

Be sure to minimize the volume level on the receiver

before conﬁguring the speaker impedance.

Conﬁguring the Speaker Impedance

Turn on the power.

Press the [RECEIVER] button

and then the SETUP button on

the remote controller.

RECEIVER

ENTER

SET UP

Use the Up and Down [▲]/[▼]

buttons to select “1. Hardware

set,” and then press [ENTER].

The Hardware Setup menu appears on

the display.

Use the Up and Down [▲]/[▼]

buttons to select “Impedance: 8

ohms” indication.

Change the impedance value to

“6 ohms” using the Left and

Right [ ]/[ ] buttons.

Press the SETUP button on the

remote controller to complete the

setting.

When you restore the impedance

setting to 8 ohms, use the same

procedures above.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

No comments

ONKYO TX-8555 User Manual Page 15