ONKYO A-9030 Instruction Manual download pdf (Page 24)

You can adjust the bass, treble and left/right output

balance respectively.

■ Operating on the integrated amplifier

Tip

• By default, bass, treble and balance is set to the center position.

Note

• While the Direct function is enabled, bass and treble are

disabled.

You can temporarily mute the output of the integrated

amplifier.

Note

• While the integrated amplifier is muted:

– Adjusting the volume or setting the integrated amplifier to

Standby will unmute the integrated amplifier.

Note

• Always turn down the volume before connecting your

headphones.

• When headphones are connected, the SPEAKERS button

cannot be used.

Adjusting the Bass, Treble and Balance

Turn the BASS –/+, TREBLE –/+ and BALANCE

L/R knobs.

BASS –/+ TREBLE –/+ BALANCE L/R

Muting the Sound

Press MUTING.

The SPEAKERS (A/B) and SELECTOR LEDs blink.

To unmute the integrated amplifier, press MUTING

again.

Using Headphones

Connect a pair of stereo headphones with a

standard plug (1/4 inch or 6.3 mm) to the PHONES

jack.

When connecting the headphones, the SPEAKERS

(A/B) LEDs go off.

You can adjust the volume and mute the sound, by

using VOLUME q/w.

While headphones are connected, no sound is output

from the speakers and PRE OUT jacks.

MUTING

PHONES jack

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

No comments

ONKYO A-9030 Instruction Manual Page 24