Onkyo TX-DS676 User Manual download pdf (Page 14)

Making antenna connections

Connecting the antenna cable to the 75/300 ohm

antenna adapter (Other than North America and

European models)

Connecting the 300 ohm ribbon wire:

Loosen the screws and wrap the wire around these screws. Then

tighten the screws with a screwdriver.

Connecting the coaxial cable:

1. With your fingernail or a small screwdriver, press the stoppers

outward and remove the cover.

2. Remove the transformer wire A from slit B and insert it into slit

3. Prepare the coaxial cable as shown in the diagram.

Connect the 75/300 ohm antenna adapter to the coaxial cable.

1 Insert the end of the cable.

2 Clamp it in place with pliers.

4. Re-install the cover.

Directional Iinkage

Do not use the same antenna for both FM and TV (or VCR) recep-

tion since the FM and TV (or VCR) signals can interfere with each

other. If you must use a common FM/TV (or VCR) antenna, use a

directional linkage type splitter.

Assembling the AM loop antenna

Assemble the loop antenna as shown in the illustration.

• Refer to the next page for details on connecting the AM loop

antenna.

Connecting the antenna cable

1. Press down the lever.

2. Insert the wire into the hole.

3. Release the lever to replace it.

12 3

✦

15mm

Outdoor

antenna

Indoor

antenna

300 ohms

ribbon wire

Slit B

Wire A

Slit C

Directional linkage

type splitter

To TV (or VCR)

To receiver

Insert into the hole.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 63 64

Comments to this Manuals

No comments

Onkyo TX-DS676 User Manual Page 14

Comments to this Manuals

Related products and manuals for Acoustics Onkyo TX-DS676