Onkyo HT-R758 User Manual Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 132
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
Connections
En-17
With u (Remote Interactive), you can use the following
special functions:
System On/Auto Power On
When you start playback on a component connected via
u, while the AV receiver is on standby, the AV
receiver will automatically turn on and select that
component as the input source.
Direct Change
When playback is started on a component connected via
u, the AV receiver automatically selects that
component as the input source.
Remote Control
You can use the AV receiver’s remote controller to
control your other u-capable Onkyo components,
pointing the remote controller at the AV receiver’s
remote control sensor instead of the component. You
must enter the appropriate remote control code first
( page 59).
Note
•Use only u cables for u connections. u cables are supplied
with Onkyo components.
Some components have two u jacks. You can connect either
one to the AV receiver. The other jack is for connecting
additional u-capable components.
Connect only Onkyo components to u jacks. Connecting other
manufacturer’s components may cause a malfunction.
Some components may not support all u functions. Refer to the
manuals supplied with your Onkyo components.
While Zone 2 is on, the System On/Auto Power On and Direct
Change u functions do not work.
Connecting Onkyo u Components
1
Make sure that each Onkyo component is connected
with an analog audio cable (connection
G in the
hookup examples) ( page 16).
2
Make the u connection (see the illustration).
3
If you’re using an RI Dock, or cassette tape deck,
change the Input Display ( page 40).
L R
ANALOG
AUDIO OUT
L R
ANALOG
AUDIO OUT
e.g., cassette tape deck
RI Dock
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 131 132

Comments to this Manuals

No comments