ONKYO PR-SC5507 User Manual download pdf

Firmware Update for the TX-NR1007/3007/5007

We are pleased to offer this firmware update for the best possible performance of your AV

Receiver.

The firmware update may fail if an external HDMI control signal is input during the update

procedure. Please be sure to turn off the HDMI control function (RIHD) on your A/V receiver

before starting the update.

How to turn off RIHD:

In the Main menu select "7. Hardware Setup", then "7-4. HDMI".

Set "HDMI Control" to OFF.

· Please read the update instructions carefully before beginning.

· The firmware update should take 30 to 40 minutes. Once the update begins, don't turn off the

power supply to the A/V receiver until it is time to restart it.

· Depending on the conditions of the network, a firmware update via a network may take more

than one hour or even fail to finish. If the update is not completed within two hours, turn off

the power supply by pushing the ON/STANDBY button and then try updating again from

the beginning.

· Updating the firmware and adjusting the settings will be done automatically, but may take

some time to complete. Please follow the procedures as instructed when you update. Note

that the update may fail, or cause problems for your A/V receiver, if you do any of the

following:

• Pull out the A/V receiver’s power cord;

• Interrupt the power supply to the A/V receiver (e.g. if the breaker is tripped or if there is an

electrical outage);

• Insert or remove the LAN cable from a device in your network when updating over a

network;

• Insert or remove a USB memory device from the A/V receiver when updating via USB;

• Operate components connected to the A/V receiver via HDMI, such as a TV or a recording

device.

If your A/V receiver is damaged for any of the reasons above, an Onkyo service center will

repair the unit for a fee.

1 2 3 4 5 6 7

Troubleshooting 5

Summary of Contents

Page 1

Firmware Update for the TX-NR1007/3007/5007 We are pleased to offer this firmware update for the best possible performance of your AV Receiver. T

Page 2

Firmware Update for the TX-NR1007/3007/5007 A firmware update is now available through the Network connection on the TX-NR1007/3007 and 5007 as we

Page 3

Firmware Update for the TX-NR1007/3007/5007 There are the following methods to update the firmware: via network and via USB storage. Please choos

Page 4

Updating the Firmware via Network TX-NR1007/3007/5007 allow you to update firmware using Network connection on rear panel. * In this procedure, on-sc

Page 5 - Troubleshooting

Troubleshooting Error Code Description *-10, *-20 Ethernet cable is not detected. Connect the cable properly. See the instruction manual for the

Page 6

Updating the Firmware via USB TX-NR3007/5007 allow you to update firmware using a USB storage device. * In this procedure, on-screen display may vary

Page 7

Updating the Firmware via USB Step 11: Select “Update” and push [ENTER]. Updating will begin. As the updating progresses, the TV screen may disappear

Comments to this Manuals

No comments

ONKYO PR-SC5507 User Manual

Browse online or download User Manual for Routers ONKYO PR-SC5507. Onkyo PR-SC5507 User's Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Routers ONKYO PR-SC5507