Onkyo R-801A User Manual Page 48

  • Download
  • Add to my manuals
  • Print
  • Page
    / 52
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 47
48
Troubleshooting
If you have any problems with the unit, please check the troubleshooting table below rst. For
any problems not covered in the table, please consult your nearest ONKYO authorized service
center.
Symptom Cause Remedy
The unit doesnt turn
on.
The AC power cord is not fully
inserted into the wall outlet.
Insert the AC power cord (mains
lead) plug into the wall outlet
(the mains) securely.
Sound is reproduced
from neither left or
right speaker.
The wire of the speaker cord is
touching the other jacks, con-
nectors, or metal parts.
The volume level is turned
down to the minimum.
The sound is muted with the
muting function.
The headphones are connected
to the PHONES jack.
The audio signal is not being
input from the connected CD
player or MD recorder.
Timer recording is in process.
Check the speaker connections
(see page 16).
Adjust the volume level (see
page 27).
Press MUTING button on the
remote controller to restore the
sound (see page 29).
Turn down the volume level
rst, then disconnect the head-
phones. Then, readjust the vol-
ume level.
Check the connected CD player
or MD recorder.
During timer recording, the
sound is muted. If you wish to
listen to the sound, press the
MUTING button on the remote
controller to cancel mute.
Sound is reproduced
from only one speaker.
The speaker cord is not con-
nected properly or rmly, or is
disconnected.
Check the speaker connections
(see page 16).
No sound is repro-
duced when the
(wake-up) timer oper-
ates.
The volume level is turned
down to the minimum.
Adjust the volume to the proper
level when you set the timer
(see page 27).
The remote control
doesnt operate.
The batteries in the remote
controller are dead.
The remote controller is out of
the control range.
There is some obstruction
between the remote controller
and the unit.
Replace the batteries with new
ones (see page 20).
Operate the remote controller
within the control range (see
page 20).
Try to operate the remote con-
troller from a different angle, or
remove the obstruction.
Page view 47
1 2 ... 43 44 45 46 47 48 49 50 51 52

Comments to this Manuals

No comments