ONKYO CS-N765 Instruction Manual download pdf (Page 14)

Getting started

5. Connecting the power cord

Always connect the power cord to an AC outlet only after

connecting it to the AC INLET terminal of the unit.

Turning on the unit may cause a momentary power surge

that might interfere with other electrical equipment on the

same circuit. If this is a problem, plug the unit into a

different branch circuit.

Disconnect the power cord only after putting the unit into

standby mode. To avoid electrical shock, always

disconnect the power cord from the AC outlet before

disconnecting the other end.

0 This unit consumes power when in standby mode.

6. Turning on the unit

1. Press the Í button.

0 If you turn on the unit when the input source is set to

USB or NET, “Now Initializing...” appears on the dis-

play. It will take 20–30 seconds until the unit

recognizes the input.

To return the unit to standby mode, press the Í button

again.

Do not use a power cord other than the one supplied

with this unit. Before connecting the power cord,

connect all of your speakers and components.

About the Auto Standby function: The Auto

Standby function is set to “On” by default. This means

when the unit is left without audio input for 2 hours, it

will automatically enter standby mode.

to an AC outlet

CR-N765_eng.book 14 ページ２０１４年８月２９日　金曜日　午後２時１８分

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

No comments

ONKYO CS-N765 Instruction Manual Page 14