ONKYO MD-101A User Manual download pdf (Page 8)

8

Using the remote controller

Inserting the remote controller

batteries

1 Remove the battery compart-

ment cover by opening it as

shown in the illustration.

Using the remote controller

Point the remote controller toward the remote

control sensor.

With the supplied remote controller

(RC-475MD)

2 Insert two AA (R6 or UM-3)-size

batteries into the battery com-

partment.

Carefully follow the polarity diagram

(positive(+) and negative (–) symbols) inside

the battery compartment.

3 Replace the compartment cover.

Notes

• Do not mix new batteries with old batteries or

different kinds of batteries.

• To avoid corrosion, remove the batteries if the

remote controller is not to be used for a long

period of time.

• Remove dead batteries immediately to avoid

damage from corrosion. If the remote

controller doesn't operate smoothly, replace

both batteries at the same time.

• The life of the batteries supplied is about six

months, but will vary depending on usage.

Remote

control sensor

30°

30°

MD-101A

RC-475MD

Notes

• Locate the unit away from strong light, such

as direct sunlight or inverted flourescent light,

which can prevent proper operation of the

remote contoroller.

• Using another remote controller of the same

type in the same room or using the unit near

equipment that uses infrared rays may cause

operational interference.

• Do not put any object (such as a book) on the

remote controller. The buttons of the remote

controller may be pressed accidentally and

drain the batteries.

• Make sure the audio rack doors do not have

colored or tinted glass. Placing the unit behind

such doors may prevent proper remote

controller operation.

• If there is any obstacle between the remote

controller and the remote control sensor, the

remote controller will not operate.

Remote controller RC-466S

When you use the remote controller RC-466S

supplied with the amplifier R-801A, operate the

remote controller by pointing it towards the

amplifier‘s remote sensor.

Be sure to make the

connection securely. If

the connection is incomplete, you will be unable

to use the remote controller to operate the unit.

MD-101A

R-801A

RC-466S

30°

30°

Remote

control sensor

About 5m

(16 feet)

About 5m

(16 feet)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 51 52

Comments to this Manuals

No comments