ONKYO K-505TX User Manual download pdf (Page 24)

24

Troubleshooting (continued)

Symptom

High frequencies are too

strong.

No high frequency sounds

are heard.

The skip function doesn’t

operate properly.

Auto Reverse doesn’t

operate properly.

Auto Reverse operates even

though the tape has not

reached the end.

The unit doesn’t operate

properly.

Remedy

• Set the proper Dolby NR mode

(see pages 9 and 15) before you

start playing the tape.

• Check the detection holes are not

covered, and that you are using a

cassette which meets the tape

standard (see page 10).

• Set the proper Dolby NR mode

(see pages 9 and 15) before you

start playing the tape.

• Clean the tape head (see page 22).

Insert the blank section properly (see

page 14).

• Set the reverse mode to (see

page 9).

• Use a cassette with suitable

leader.

• Use a new cassette.

• Set the one-way playback mode

( ) (see page 9).

Turn off the unit for more than ten

seconds, and turn it on again.

If the unit still remains inoperable,

disconnect the AC power cord

(mains lead) from the wall outlet

(the mains) and connect it again.

Cause

• The Dolby NR mode setting is not

matched to the one the tape was

recorded with.

• Automatic tape-type detection is

not operating properly.

• The Dolby NR mode setting is not

matched to the one the tape was

recorded with.

• The tape head is dirty.

The blank section between tracks is

too short or noisy.

• The reverse mode is not set to

.

• The cassette has no leader or the

leader is not transparent.

The tape is creased, wrinkled, or

scratched.

The internal microcomputer of the

unit is being affected by the power

supply or static electricity.

1 2 ... 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments