ONKYO T-405TX User Manual download pdf (Page 4)

Precautions

1. Warranty Claim

You can find the serial number on the rear panel of

this unit. In case of warranty claim, please report this

number.

2. Care

From time to time you should wipe the front and

rear panels and the cabinet with a soft cloth. For

heavier dirt, dampen a soft cloth in a weak solution

of mild detergent and water, wring it out dry, and

wipe off the dirt. Following this, dry immediately with

a clean cloth. Do not use rough material, thinners,

alcohol or other chemical solvents or cloths since

these could damage the finish or remove the panel

lettering.

3. Power

WARNING

BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME,

READ THE FOLLOWING SECTION CAREFULLY.

The voltage of the available power supply differs

according to country or region. Be sure that the

power supply voltage of the area where this unit will

be used meets the required voltage (e.g., AC 230 V,

50 Hz or AC 120 V, 60 Hz) written on the rear panel.

Setting the STANDBY button to standby does not

shut off the power completely. So the power cord

should be removed from the AC outlet when the

unit is not used for a prolonged time.

For British model

Replacement and mounting of an AC plug on the

power supply cord of this unit should be performed

only by qualified service personnel.

IMPORTANT

The wires in the mains lead are coloured in

accordance with the following code:

Blue : Neutral

Brown : Live

As the colours of the wires in the mains lead of this

apparatus may not correspond with the coloured

markings identifying the terminals in your plug,

proceed as follows:

The wire which is coloured blue must be connected

to the terminal which is marked with the letter N or

coloured black.

The wire which is coloured brown must be

connected to the terminal which is marked with the

letter L or coloured red.

IMPORTANT

A 5 ampere fuse is fitted in this plug. Should the fuse

need to be replaced, please ensure that the

replacement fuse has a rating of 5 amperes and that it

is approved by ASTA or BSI to BS1362. Check for the

ASTA mark or the BSI mark on the body of the fuse.

IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR

THE SOCKET OUTLET IN YOUR HOME THEN THE

FUSE SHOULD BE REMOVED AND THE PLUG CUT

OFF AND DISPOSED OF SAFELY. THERE IS A DANGER

OF SEVERE ELECTRICAL SHOCK IF THE CUT OFF

PLUG IS INSERTED INTO ANY 13 AMPERE SOCKET.

If in any doubt, please consult a qualified electrician.

For U.S. model

Note to CATV system installer:

This reminder is provided to call the CATV system

installer’s attention to Article 820-40 of the NEC,

ANSI/NFPA 70, which provides guidelines for proper

grounding and, in particular, specifies that the cable

ground shall be connected to the grounding system

of the building, as close to the point of cable entry

as practical.

FCC Information for User

CAUTION:

The user changes or modifications not expressly

approved by the party responsible for compliance

could void the user’s authority to operate the

equipment.

NOTE:

This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful

interference in a residential installation. This

equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However,

there is no guarantee that interference will not occur

in a particular installation. If this equipment does

cause harmful interference to radio or television

reception, which can be determined by turning the

equipment off and on, the user is encouraged to try

to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment

and receiver.

• Connect the equipment into an outlet on a circuit

different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV

technician for help.

For Canadian model

For models having a power cord with a polarized

plug:

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH

WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

Modele pour les Canadien

Sur les modèles dont la fiche est polarisée:

ATTENTION:

POUR ÉVITER LES CHOCS ÉLECTRIQUES,

INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE

DANS LA BORNE CORRESPONDANTE DE LA PRISE

ET POUSSER JUSQU’AU FOND.

1 2 3 4 5 6 7 8 9 ... 31 32

Comments to this Manuals

No comments

ONKYO T-405TX User Manual Page 4

Comments to this Manuals

Related products and manuals for Audio tuners ONKYO T-405TX